HEX
HEAD SPINDLE ASSEMBLY
The hex head spindle assembly
is for heavy duty applications. A
replaceable slip-on neoprene cap can
be added to the hex head to give it
a cushion surface. |
|
NEOPRENE
TIP SPINDLE ASSEMBLY
The bonded neoprene tip has good oil
and solvent resistant properties.
It will not mar the work surface.
The cushion will take up minor variations
in thickness and will tolerate slightly
unlevel surfaces. However, only light
load is recommended for the neoprene
tip spindle. |
|
| Cone
Cushion-Tip Bonded Neoprene Cap |
P/N 81-206
|
FLANGE
WASHER
Two washers supplied with U-bar type
toggle clamp. |
P/N 81-120
|
SWIVEL
PAD ASSEMBLY:
The swivel pad spindle assembly has
a large flat contact surface.
The floating pad can swivel 12 degrees
in each direction to accommodate an
unlevel surface. It is copper plated
and will not pick up splash from welding.
|
|
NEOPRENE
CAPS
Slip on the heads of hex
head spindles.
Durometer: 60-70
Normal operating range: -40o to 220o
F. Special
Neoprene Caps.
Slip on threaded spindle rod. |
P/N 81-330
|
Bolt
Retainers:
One bolt retainer supplied with solid
bar type toggle clamp. |
|
T-SLOT
ADAPTOR PLATES
The T-slot adaptor plates can be used
to mount specific toggle clamp models
80-040, 80-220, 80-240, 80-250 on
tables with T-slots. The adaptor plates
are available in two heights and can
also be used in conjunction with the
following vertical extension brackets:
81-048, 81-248, and 81-288. The adaptor
plates can be used as riser blocks
in order to increase toggle clamp
bar clearance. |
|
P/N